Always here, Always available
+1 410-604-2900
Quote Request List
high voltage components
The latest from
Miltec.
-
Potential Transformer
This Potential Transformer is designed to reduce the UV lamp voltage to a safe level so that the Panel mounted Volt Meter can display the UV lamp voltage readout. The Potential Transformer can also output the reduced voltage signal to a Miltec LVM sensor board.
-
Panel Mount Voltmeter | 3.5 Inch | 2500 Volt
This is a Volt Meter designed to mount to the front panel of a power supply cabinet to allow the operator to easily read the actual UV lamp operating voltage. This is very helpful when trying to troubleshoot a UV system or UV lamp problem. Direct replacement for all Aetek panel mount voltmeters.
-
Panel Mount Ammeter | 3.5 Inch | 0-15 Amp Scale
This is an AMP Meter that is designed to mount onto the front panel of a power supply cabinet to allow the operator to easily read the UV lamp amperage to verify that the lamp amperage is operating at the correct level.
-
Mercury Contactor | 120V Coil | Normally Open
This is a high voltage Mercury Contactor that energizes or switches capacitors on or off in order to change the UV lamp power level.
-
Mercury Contactor |120V Coil | Normally Closed
This is a high voltage mercury contactor, used to switch high voltage capacitors for changing power levels.
-
Mercury Contactor | 2 Pole | 120V | Normally Open
This is a two pole High Voltage Mercury Contactor that energizes or switches capacitors on or off in order to change the UV lamp power level.
-
Mercury Contactor | 24 VDC | Normally Open
Direct replacement Mercury Contactor for all Prime UV constant wattage power supplies, used to switch high voltage capacitors for changing lamp power levels.
-
Mercury Contactor | 24VDC | Normally Open
This is a high voltage Mercury Contactor that energizes or switches capacitors on or off in order to change the UV lamp power level.
-
Spring Tension | Side B | Ceramic Lamp Holder
Our Team
Our people set us apart.
Our friendly team of experts is always here to help.
Count on them for solutions, ideas, support, and guidance.
Headquarters
146 Log Canoe Circle
Stevensville, Maryland 21666 USA
Support
Phone: +1 410-604-2900
Email: service@miltec.com
After Hours Technical Support
(5 pm – 8 am EST) (GMT -5):
+1 443-591-2326
Sales
Phone: +1 410-604-2900
Fax: (+1) 410-604-2906
Email: sales@miltec.com
Photography by David Bohrer, National Assoc. of Manufacturers and Gary Landsman, Gary Landsman Photography
©2024 Miltec UV. All Rights Reserved. Privacy Policy / Terms and Conditions